D2NA Control panel issue
Inviato: 14/07/2025, 19:50
Hi! I have a Rimor from 2001 with a D2NA control panel.
Lately the panel has been behaving strangely. First when you put power on to it it works normal. Then after approximately 1 hour it started to behave strangely. Sometimes the button to the waterpump activated itself and the pump went on. Sometimes the button to the lightning activated itself and the light went on.
Then if you tried to push the buttons or tried to navigate you did get bad reaction or no reaction at all. After that I disconneted the power and waited for some hours. I put the power on again and then panel repeated the same behavior as described above.
For the moment the panel only lights up when I connect the power and I don't get any reaction at all when I push a button.
I found out that on the backside of the panel (See attached picture: ArSilicii D2NA_02.JPG) there's is a black electrical component that is broken. It's a "Power inductor" made by Elettronica Rossini S.r.l. I would like to try to put a new inductor in place and see if that solves the issue. The problem is that the technical data is missing on the conductor so I don't know which size I should buy.
Is there any one on this forum who have got some information about this I would be grateful.
FYI! It seems like there is an issue to attache a picture, but I hope for the best.
Kind regards
Martin
Lately the panel has been behaving strangely. First when you put power on to it it works normal. Then after approximately 1 hour it started to behave strangely. Sometimes the button to the waterpump activated itself and the pump went on. Sometimes the button to the lightning activated itself and the light went on.
Then if you tried to push the buttons or tried to navigate you did get bad reaction or no reaction at all. After that I disconneted the power and waited for some hours. I put the power on again and then panel repeated the same behavior as described above.
For the moment the panel only lights up when I connect the power and I don't get any reaction at all when I push a button.
I found out that on the backside of the panel (See attached picture: ArSilicii D2NA_02.JPG) there's is a black electrical component that is broken. It's a "Power inductor" made by Elettronica Rossini S.r.l. I would like to try to put a new inductor in place and see if that solves the issue. The problem is that the technical data is missing on the conductor so I don't know which size I should buy.
Is there any one on this forum who have got some information about this I would be grateful.
FYI! It seems like there is an issue to attache a picture, but I hope for the best.
Kind regards
Martin