ArSilicii

In my Rimor europeo 2004 by mistake i short circuit lamp connectors and all the lamp vent black restarted the system but no light still control panel show green light what to do any hidden fuses, replace ?
Thanks Peter

Hello. On our board there is a elettronic fuses. If you have a short circuit you need to replace it and (with a restart) the system work again.

Should not be an short circuit since just a brief touch when changing lampholder. Control panel shows green light bit less bright when turn light button and only one lamp about 50% less light when try two lamps both goes off restart of al110 one lamp works again Old 11w not work on only led bulbs...

Hello. With 230V the problem solved?
I suppose that you have a supply problem. Try to clean and tight all connectors from power supply to control panel and check if the problem solved. If you not solve it, we suggest to send me a little video with the problem by whattsapp at +390577988316.

Hi ! Checked all connections measured out power from battery 13.8 to system. Also checked all 2pin out marked light 13.8v al110 What happend today kitchen light normal and when i push light button in living area no light and kitchen light turns off. Couldnt film because couldnt get light on again...when pushing lamp on button green light on control unit goes off barely visible and when turning lamp off it light up again.
Also measured kitchen lamp holder 13.8v when turned on
230v or only 12v same problem

Its difficult for me find your problem. We suggest to go to a dealer and check the system.

Hi again with a little help some more info...
From al110s to control power normal 12v but measuring from 2pin connector on the controlpanel back only between 5-6volt and about the same in lampholder.
What happend before was that when restart system check voltage in lampholder its ok 12v but as son as press light on it goes to between 5-6v same as output connector controlpanel.
My quess is controlpanel but what is controlling output power?

Have tried retailer but they could not help only one in sweden hopefully this info can bring som fix ?
Thanks

Hello
Probably the problem is on control panel. The problem is on output section or on lights switch